Argon

574.80 € 478.80 € inc. VAT
479.00 € 399.00 € ex. VAT

STATE OF THE ART SERVO DRIVE

  • High dynamic range torque control
  • Wide range motor support, from DC, BLDC, AC and Linear, from 50 W to 1500 W
  • Sophisticated dead-time distortion elimination
  • Flexible feedback device port supporting incremental, serial and analog encoders and resolvers
  • Dual CPU architecture with dedicated open source ARM CPU for user functionality
  • High functional density and cost efficiency: all features included in the standard model
  • 3-level PWM output with reduced motor heating
DescriptionDownloads

CONTROL :

  • Input setpoint signals including pulse and direction, quadrature, analog and PWM
  • Internal axis homing function with sensorless hard-stop operating mode
  • Multidrop capable realtime SimpleMotion V2 field bus for setup & control

PROTECTIONS & RUGGEDNESS

  • 4-way Safe torque off with motor braking
  • Prevent machine damage via I²t (motor temperature modelling), blocked motion and tracking error detection
  • Industry leading ruggedness: over current, short circuit, over voltage, under voltage and over temperature protections, internally fused, data/communication error detection
  • CE compliance

ELECTRICAL SPECIFICATIONS

Continuous output current 0-10 A (7 A RMS)
Peak output current 0-15 A (10.6 A RMS)
Power conversion efficiency 90-95 %
Logic power supply 24 VDC +/- 10%, 0.1 – 0.5 A
Motor power supply 85 – 264 VAC 50/60 Hz, 0 – 15 A


See full specifications here

SUPPORTED MOTORS

As motor is not included, make sure that you have, or obtain a motor that is compatible with the Argon.

Servo motor requirements:

  • Permanent magnet brush-DC, AC, brushless or linear motor
  • Motor voltage rating 85-264 VAC
  • Motor current rating 0.5 – 15A
  • Servo motor must be equipped with an position sensor with a resolution of 100 to 1000000 pulses per revolution.

Stepping motor requirements:

  • Two-phase stepping motor with 0.5 – 10A current rating, no feedback device needed. Can be used in position and velocity control mode. Torque control mode not possible with stepper.

INCLUDED ITEMS